■ Bradford White ICON System™*—Intelligent gas control with proven millivolt powered technology and built-in piezo igniter. A standard, off the shelf thermopile converts heat energy from the pilot flame into electrical energy to operate the gas valve and microprocessor. No need for external electricity. — Enhanced Performance—Proprietary algorithms provide enhanced First Hour Rating and tighter temperature differential. — Advanced Temperature Control System—Microprocessor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels.
— Intelligent Diagnostics—An exclusive green LED light prompts the installer during start-up and provides ten different diagnostic codes to assist in troubleshooting.
— Pilot On Indication—Flashing green LED provides positive indication that pilot is on.
— Separate Immersed Thermowell—High-strength advanced polymer composite thermowell provides isolation between electric temperature sensor and surrounding water. No need to drain the tank when removing gas valve.
■ Advanced ScreenLok® Technology Flame Arrestor Design—Flame arrestor is designed to prevent ignition of flammable vapor outside of the water heater.
■ Resettable Thermal Switch—Proven and reliable bimetallic switch prevents burner and pilot operation in case of ongoing flammable vapors burning inside of the combustion chamber or restricted air flow.
■ Maintenance-Free—No regular cleaning of air inlet openings or flame arrestor is required under normal conditions.
■ Sight Window—Offers a view into the combustion chamber to observe the operation of the pilot and burner.
■ Factory-Installed Hydrojet® Total Performance System—Sediment reducing device that also increases first hour rating of hot water while minimizing temperature build-up in tank.
■ Vitraglas® Lining—An exclusively engineered enamel formula that provides superior tank protection from the highly corrosive effects of hot water. This formula (Vitraglas®) is fused to the steel surface by firing at a temperature of over 1600°F (871°C).
■ Insulation System—Non-CFC foam covers the sides and top of the tank, reducing heat loss. This results in less energy consumption, improved efficiencies, and jacket rigidity.
■ Pedestal Base.
■ Water Connections—3⁄4″ (19mm) NPT factory installed true dielectric fittings.
■ Factory-Installed Heat Traps.
■ Protective Magnesium Anode Rod.
■ 3×4 “Snap Lock” Draft Diverter—Allows either 3″ (76mm) or 4″ (102mm) vent connections with inputs of 40,000 BTU/Hr. or less. Over 40,000 BTU/Hr. has the 4″ (102mm) “Snap Lock” Draft Diverter.
■ T&P Relief Valve—Installed. ■ Low Restrictive Brass Drain Valve—Durable tamper proof design.
■ NOx Emissions—Less than 40 ng/J.